Tiles are widely used in our daily lives. Acid-resistant tiles, as a type of tile, have strong corrosion resistance and are a common building material used in acidic and alkaline environments. They possess excellent acid and alkali resistance and high-temperature resistance. They are widely used in industrial production, chemical laboratories, and acid and alkali storage rooms. Proper installation methods ensure the lifespan and effectiveness of acid-resistant tiles. So, do you know how to install acid-resistant tiles? Below, we will introduce it in detail.
Surface Treatment: Before laying acid-resistant tiles, the ground must be thoroughly cleaned. The surface should be free of visible sand, dust, particles, oil stains, etc. Simultaneously, soak the acid-resistant tiles in water and then let them dry, achieving a dry exterior and moist interior effect. Before installation, ensure the surface is free of watermarks.
Drawing Cross Lines: Before laying acid-resistant tiles, use a spirit level to ensure the tiles are laid horizontally and vertically. Draw cross lines in both the horizontal and vertical directions first. This ensures better control during installation, preventing misalignment and achieving an aesthetically pleasing result.
Tile Arrangement
Before laying acid-resistant tiles, ensure the base surface is flat and hardened. When laying, first hold the acid-resistant tile at a slight angle to the surface, then gently push it horizontally by hand, lightly squeezing and pressing to ensure the bottom of the tile is level with the surface. This helps remove air bubbles and prevents hollow spots. Afterward, gently tap the tile surface with the handle of a hammer to ensure the bottom of the tile fully contacts the adhesive mortar, then use a wooden mallet to flatten the tile surface.
Groove Cleaning
Keep the grout lines clean during acid-resistant tile laying. Within 24 hours of laying, clean all cement mortar from the grout lines to facilitate grouting later.
Covering with Cardboard
After laying the acid-resistant tiles, cover them with thick cardboard to prevent debris from affecting the finish. Seal the gaps between the cardboard pieces tightly with sealant.
Groogging
After cleaning the grout lines, mix white water and talcum powder to form a putty. Apply the putty 1mm below the tile surface. After grouting is completed, maintain a well-ventilated and dry environment. Once dry, check the effect of the acid-resistant tiles. If everything is normal, the installation is complete.
